Preparing The Engine For First Start-Up; Tests Before The First Start-Up; Fuel Tank Suction - Iveco N45 MNA M10 Installation Directive Manual

MAY 2006
22. PREPARING THE ENGINE FOR FIRST
START-UP
1. Drain the residual 30/M protective oil from the sump.
2. Pour into the lubricating loop only lubricating oil of the
type and in the quantities set out in the Refilling Table.
3. Drain the CFB protective liquid from the fuel loop,
completing the operations as indicated under item 3. of
Chapter 26.
4. Remove the caps and/or seals from the engine intake,
exhaust, aeration and venting ports, restoring normal
conditions of use. Connect the inlet of the turbocharger
to the air filter.
5. Connect the fuel loops to the boat tank, completing
the operations set out in item 4. of Chapter 26. During
filling operations, connect the pipe returning fuel to the
tank to a collecting container, to prevent residues of CFB
protective liquid from ending up into the boat tank.
6. Verify and refill engine coolant as prescribed.
7. Remove from the engine the labels with the inscription
"ENGINE WITHOUT OIL".
insTAllATiOn direcTiVe

23. TESTS BEFORE THE FIRST START-UP

Although they are extremely important, "common sense"
checks such as the exposure of sensitive parts (plastics, wire
harness, electronic units, etc...) to heat, and those that for
years have characterized the quality of the work performed
in the yard, are not mentioned herein.
Tests of the proper operation of the engine and the
components of the system may be performed rapidly
and with the utmost reliability using specific diagnostic
tools, available from IVECO MOTORS Technical Assistance
Centers.

Fuel tank suction

Verify the fuel suction at the maximum allowed longitudinal
and transverse inclination, with the residual quantity of
fuel considered "RESERVE", such as to cause the reserve
indicator light to be permanently lighted.
Instrument panel
Verify the efficiency of all light indicators, as described in the
related Chapters.
N45 MNA M10
67
N67 MNA M15