Table of Contents
Advertisement
N45 MNA M10
0
N67 MNA M15
12. M10.00/M15.00 CUSTOMIZED INSTRUMENT PANEL
Using only the components of the panel that are not wired
to allow for panel customization, they will have to be wired
using the 10 meter long wire harness, set up at one end for
coupling to the JB connector and at the opposite end with
conductors with free terminals with identifying numbering
on each wire. The conductors will have to be connected to
the individual components as indicated in the electrical and
wiring diagrams in Chapter 13.
CAUTION
To assure the functionality of the safeties pertaining to the
engine start/stop commands from the instrument panel
or engine room, it is mandatory to wire the key switch
strictly as shown in the electrical diagrams in chapter 1.
The wiring details of the indications and alarms module
alone are provided below; indications for IVECO MOTORS
indicator instruments, are shown in the related wiring dia-
grams in Chapter 13.
JD Connector for indications and alarms
module
Figure 27
VIEW FROM THE INTEGRATED SIDE
IN THE REAR PART OF THE MODULE
insTAllATiOn direcTiVe
4
3
2
1
8
7
6
5
12 11
10 9
16 15
14
13
20 19
18
17
24 23
22
21
05_034_C
Figure 2
1
5
9
13
17 18 19 20
21 22 23 24
VIEW FROM THE TERMINAL SIDE
OF THE COUPLING SIDE WIRING
connector
TRIDENT / ITT CANNON
terminal
female
lid
rear
JD connects the indications and alarms module to the elec-
trical system of the engine (sensors, power supply, etc.).
The terminal part of the wire harness, supplied with the
module, must be completed using female terminals, as
described in the electrical diagram of Chapter 13.
Gather essential information, the following ways must be
wired: 1, 7, 8, 9, 10, 13, 14, 15, 17, 18, 19 with the female
terminals supplied as standard equipment.
MAY 2006
2
3
4
6
7
8
10 11 12
14 15 16
04_241_N
part TST 24PA00
part 192990-0050
part TST24AH00
Hide quick links:
Advertisement
Table of Contents
