Fisher & Paykel CG604DX Installation Instructions Manual page 10

6 DISCARD PACKAGING
Model may vary from illustrations shown
8 APPLY ADHESIVE FOAM TAPE AROUND EDGE
Floating nut
Adhesive side
Ensure edge of tape
lines up with outer
edge of cooktop
8
Recycle responsibly
Fibre washer Elbow (½" BSP external thread)
Foam Tape
1 Turn the cooktop upside down and
place it on a soft surface.
2 Spread the seal around the edges,
with the adhesive side facing down
to form a continuous seal around
the cooktop.
3 Using a sharp cutter or trimmer
knife, trim the excess sealing
material around the edge of the
cooktop. Take care not to damage
x 4
the benchtop.
7 FIT THE ELBOW AND WASHER
Adhesive side
Ensure edge of tape
lines up with outer
edge of cooktop
Fibre washer
Floating nut
9 LOWER GENTLY INTO THE CUTOUT
NG Models
Make sure to t the supplied
Washer
washer and regulator.
Adjust to obtain a test point
pressure of 1 kPa with the two
Arrow
semi-rapid burners operating at
highest setting.
ALL Models
Make sure the connection point will be accessible with the cooktop installed.
To enable the gas supply to be readily shut o by the customer, make sure the connection
is tted with an isolating valve close to the cooktop.
Foam Tape
Elbow (1/2" BSP external thread)
2
LPG Models
Make sure to t
washer and tes
Washer
Make sure the s
is regulated to
the two semi-ra
operating at hig