Surround Playback - Denon DHT-M330DV Operating Instructions Manual

10 SURROUND PLAYBACK

(1) Before playing with the surround function
• Adjustments using the test tones can only be performed in the
"Auto" mode and are only valid for the AUTO DECODE Surround
modes. The adjusted levels are automatically stored in the memory.
1, 4
3
1 Press the TEST TONE button.
2 Test tones are output from the different speakers.
Either turn the MASTER VOLUME dial on the main unit or
use the VOLUME buttons on the remote control unit to
adjust the volume.
Main unit
3 Use the channel volume adjust buttons to adjust so that the
volume of the test tones is the same for all the speakers.
• The ( and ) cursor buttons on the remote control unit
during the adjustments using the test tones.
4 After adjusting using the test tones, adjust the channel levels
either according to the playback sources or to suit your tastes,
as described below.
• Even after adjusting using the test tones, the various channels can
2
3
1
Remote control unit
2
+
-
3
Remote control unit
Remote control unit
4
Remote control unit
be adjusted using the procedure described below to suit the
program source and your preferences.
2, 4
1, 3
Press the CH.SELECT button on the remote control unit.
• The following is displayed:
L E V E < / L > E D L A Y
Use the select button while the above is displayed to
select "LEVEL".
• The level display shown below appears.
F L V L < O 0 d > B
Select the speaker whose level you want to adjust.
• The channel switches as shown below each time the button
is pressed.
FRONT L
END
SUBWOOFER SURROUND L
Adjust the volume level of the selected speaker while the
channel level is displayed.
Once the channel level setting is completed, select "END" at step
3. The display returns to normal after several seconds.
ENGLISH
4
Remote control unit
Remote control unit
CENTER FRONT R
SURROUND R
Remote control unit
Remote control unit
33