JK Audio that-2 User Manual page 14

FCC Registration
Your new JK Audio product has been
registered with the Federal Communications
Commission (FCC). This product complies
with the standards in Part 68 of the FCC rules.
1. Connection And Use With The
Nationwide Telephone Network
The FCC requires that you connect this
telephone equipment to the national
telephone network through a USOC RJ-11C
modular telephone jack. This equipment
may not be used with Party Line Service or
Coin Telephone Lines. This equipment is
hearing aid compatible.
10 10 10
THAT-2 Telephone Handset Audio Tap
2. Information For The Telephone Company
Upon request from your local telephone
company, you are required to provide the
following information:
a. The "line" to which you will connect
the telephone equipment (that is, your
telephone number), and
b. The telephone equipment's FCC
registration number. This can be
found on the bottom of your telephone
equipment, and,
c. The ringer equivalence number (REN)
for this equipment. The REN is used to
determine the quantity of devices which
will be connected to the telephone line.
Excessive RENs on the telephone line
may result in the devices not ringing in
response to an incoming call. In most,
but not all areas, the sum of the RENs
should not exceed 5.0. To be certain
of the number of devices that may be
connected to the line, as determined
by the total RENs, contact the local
telephone company.