GE GFDR485 Owner's Manual And Installation Instructions page 5

Control settings.
Hodels:
GFD5255
GFD5250
_er Ste_sh_
(_ Cottons 0
£iems
Bulky
8eddlng
Lock_ontrol Active
Wear
Deticates
Speed Dry
Time Add Time
GEAppliances.com
-- %
Start/Pause
0
VoJume
®--0
Power
Press to "wake up" the display. If the display is active, press to turn the dryer off.
NOTE: Pressing Power does not disconnect the appliance from the power supply.
Dry Cycles
The dry cycle controls the length and tumble speed af the drying process. The chart below will help yau match the dry
setting with the loads.
Normal/Mixed Loads For loads consisting of cottons and poly-blends.
Cottons
Far cottons and most linens.
Far large coats, bed spreads, mattress covers, sleeping bugs, blankets, comforters, jackets, small rugs,
Bulky/Bedding and similar large and bulky items.
Clothing worn for active sports exercise and some casual wear. Fabrics include new technology
Active Wear finishes and stretch fibers such as Spandex. Alsofor clothing labeled EasyCare or Permu Press:For
wrinkle-free and permanent press items.
Delicates For lingerie and special-care fabrics.
Speed Dry or For small loads that are needed in a hurry, such as sports or school uniforms. Can also be used if the
Quick Dry Dreviouscycle left some items damp, such as collars or waistbands.
Towels/Sheets Use for towels OR sheets. It is not recommended to mix towels and sheets in the same load.
Reducescertain types of bacteria by 99.8%, including: Staphylococcus aureus, Pseudomonas
Sanitize aeruginosa, and Klebsiellapneumoniae. The antibacterial process occurs when high heat is used
during a portion of this drying cycle.
Steam Dewrinkle
Provides 20 minutes of steam drying to assist with dewrinkling clothes.
Ideal for loads left in dryer
Full Loads for an extended time.
Warm Up Provides 10 minutes of warming time to warm up clothes.
Air Fluff Provides 10 minutes of tumbling time without heat.
Use to set your own dry time. Time Dry is also recommended for small loads. To use:
i. Turn dry cycle dial to Time Dry.
2. Increase the drying time by pressing the Add Time button.
Note: This button only increases the time. When max time is reached, pressing the button again
will reset the counter to the lowest setting.
3. Select the Temp.
4. Close the door.
5. Press Sturt/Pause.
Time Dry