GE GFDR485 Owner's Manual And Installation Instructions page 37

Installation Instructions
STACKING THE WASHER AND
DRYER{if desired){cont.)
INSTALLING THE STACK BRACKET
KIT
STACKING KIT GEFLSTACK CONTENTS
(OPTIONAL ACCESSORY!
NOTE: Models GFDR480, GFDR485, GFWR4800
and GFWR4805 cannot be stacked.
,o oj
I ° ° o r----
17 Left hand bracket 174 #12 x 1" screws
b °1
17 Right hand bracket
174 #8 × 1/2" screws
04 rubber pods
TOOLS YOU WILL NEED
C1Phillips screwdriver
ClOpen-ended wrench
17Gloves
C1Level
C1Pliers
INSTALLATION PREPARATION
Remove the packaging.
Flatten the product carton to use as a pad to lay the
dryer down on its side. Continue using the carton to
protect the finished floor in front of
the installation location.
I_] REMOVE THE DRYER LEVELING LEGS
A. Carefully lay the dryer on its side. Use the
packing material so you don't scratch the finish
on the dryer.
B.
0
L J
Use an open-end wrench or pliers to remove the
dryer leveling legs.
Back out and
remove all 4
leveling legs
[] INSTALL RUBBER PADS TO DRYER
BASE
Locate the 4 rubber pads in the parts package.
Remove the adhesive backing and firmly place
over each bracket where you removed the
leveling legs.
37