GE GFDR485 Owner's Manual And Installation Instructions page 34

Installation Instructions
REVERSING THE DOOR SWING (if desired}
[_] RE-LOCATE HINGE ASSEMBLY AND
HANDLE SPACER
A. Place the inner door frame on a soft and flat
surface so that the inner door gasket is facing
updwards.
B. Remove 6 screws (#8 x 1/2") that secure the
hinge assembly and handle spacer.
Ca
Separate the hinge assembly, door plug (on
some models), handle spacer or handle spacer/
latch assembly (depending on model) from the
inner door frame.
Door plug
(on some models)
Hinge
assembly
Handle spacer/
Latch assembly
(on some models)
Handle spacer
(on some models)
[_] RE-LOCATE HINGE ASSEMBLY AND
HANDLE SPACER (cont.}
D. Rotate hinge assembly 180 degrees and
re-locate it and the door plug (on some models)
on the opposite side of the inner door frame.
E. Rotate the handle spacer or handle spacer/latch
assembly (depending on model) 180 degrees and
re-locate on the opposite side of the inner door
frame.
Handle spacer/
Latch assembly
(on some models)
Door plug
(on some models)
Handle spacer Hinge
(on some models) assembly
R Re-install screws securing hinge assembly and
handle spacer.
34