Pip, Pop And Side By Side; Supplemental Information Of The Auto Brightness Function - Mitsubishi Electric DR854 User Manual

< PIP, POP and SIDE BY SIDE >
The following table shows the combination of signal inputs under which the "PIP" and "POP" modes function. These modes do
not function, however, when the screen size is "CUSTOM" or "REAL".
SUB RGB1
(HDMI)
MAIN
RGB1 (HDMI)
RGB2 (DVI-D)
RGB3 (D-SUB)
RGB4 (BNC)
RGB5* (CAT5)
RGB6 (DISPLAY PORT)
DVD/HD (YPbPr)
VIDEO<S>
VIDEO
* : RGB 5 becomes usable when the optional CAT5 Rx BOX is mounted.
Press the "PIP ON/OFF" buttons on the remote control to change between "PIP", "POP" and "SIDE BY SIDE"
mode as shown in the diagram below.
PIP
"PIP", "POP" mode resolution (Reference)
< Supplemental information of the auto brightness function >
To control multiple monitors collectively
In such a case where the tiling function is used, you can control the auto brightness function by sharing the detection result of
the brightness sensor of a certain monitor among the connected monitors.
1. Multi-connect the monitors using RS-232C or CAT5 cables separately sold as shown by the example below.
Monitor
ID = 9
(Slave)
Monitor
ID = 6
(Slave)
Monitor
ID = 3
(Slave)
2. Assign a monitor ID to each multi-connected MDT421S using MONITOR ID. (See page 31.)
Monitor ID is selectable from 1 to 26.
The monitor ID of the Master monitor should be "1" and those of the Slave monitors should be other than "1".
You are recommended to assign IDs to the monitors consecutively from 1, 2, 3, and on.
3. Set AUTO BRIGHTNESS on the OSD screen (PICTURE) as follows.
Master monitor
Slave monitors
RGB2 RGB3 RGB4
(DVI-D) (D-SUB) (BNC)
SIDE BY SIDE
POP
ASPECT
PIP SIZE
SMALL : 450 pixels X 338 pixels
MIDDLE : 675 pixels X 450 pixels
LARGE
: 900 pixels X 675 pixels
POP SIZE
: 450 pixels X 338 pixels
Monitor Monitor
ID = 8 ID = 7
(Slave) (Slave)
Monitor Monitor
ID = 5 ID = 4
(Slave) (Slave)
Monitor Monitor
ID = 2 ID = 1
(Slave) (Master)
AUTO BRIGHTNESS CONTROL
LOCAL PRIMARY
REMOTE SECONDARY
English-33
RGB5* RGB6 DVD/HD VIDEO<S>
( )
DISPLAY
(CAT5) (YPbPr)
PORT
SIDE BY SIDE
OFF
FULL
Master: Monitor configured as Master that detects
the outside light (Monitor ID is "1".)
Slave: Monitor controlled by the Master monitor
(Monitor ID is other than "1".)
VIDEO
: Supported
: Not supported