Pip, Pop And Side By Side; Supplemental Information Of The Auto Brightness Function; English - Mitsubishi Electric MDT52IS User Manual

52" lcd display monitor
Hide thumbs Also See for MDT52IS:
Table of Contents

Advertisement

< PIP, POP and SIDE BY SIDE >
The following table shows the combination of signal inputs under which the "PIP" and "POP" modes function. These modes do
not function, however, when the screen size is "CUSTOM" or "REAL".
SUB
RGB1
MAIN
(HDMI)
RGB1 (HDMI)
RGB2 (DVI-D)
RGB3 (D-SUB)
RGB4 (BNC)
RGB5 (CAT5)
DVD/HD (YPbPr)
VIDEO<S>
VIDEO
Press the "PIP ON/OFF" buttons on the remote control to change between "PIP", "POP" and "SIDE BY
SIDE" mode as shown in the diagram below.
PIP
"PIP", "POP" mode resolution (Reference)
< Supplemental information of the auto brightness function >
To control multiple monitors collectively
In such a case where the tiling function is used, you can control the auto brightness function by sharing the detection result of
the brightness sensor of a certain monitor among the connected monitors.
1. Multi-connect the monitors using RS-232C or CAT5 cables as shown by the example below.
Monitor
ID = 9
(Slave)
Monitor
ID = 6
(Slave)
Monitor
ID = 3
(Slave)
2. Assign a monitor ID to each multi-connected MDT521S using MONITOR ID.
Monitor ID is selectable from 1 to 26.
The monitor ID of the Master monitor should be "1" and those of the Slave monitors should be other than "1".
You are recommended to assign IDs to the monitors consecutively from 1, 2, 3, and on.
3. Set AUTO BRIGHTNESS on the OSD screen (PICTURE) as follows.
Master monitor
Slave monitors
RGB2
RGB3
RGB4
(DVI-D)
(D-SUB)
(BNC)
SIDE BY SIDE
POP
ASPECT
PIP SIZE
SMALL
MIDDLE
LARGE
POP SIZE
Monitor
Monitor
ID = 8
ID = 7
(Slave)
(Slave)
Monitor
Monitor
ID = 5
ID = 4
(Slave)
(Slave)
Monitor
Monitor
ID = 2
ID = 1
(Slave)
(Master)
AUTO BRIGHTNESS
LOCAL
REMOTE

English-33

RGB5
DVD/HD
VIDEO<S>
(CAT5)
(YPbPr)
SIDE BY SIDE
FULL
: 450 dots X 338 dots
: 675 dots X 450 dots
: 900 dots X 675 dots
: 450 dots X 338 dots
Master: Monitor configured as Master that detects
the outside light (Monitor ID is "1".)
Slave:
Monitor controlled by the Master monitor
(Monitor ID is other than "1".)
CONTROL
PRIMARY
SECONDARY
VIDEO
: Supported
: Not supported
OFF

Advertisement

Table of Contents
loading

Table of Contents