Functional Description - Makita BVF154 Instruction Manual

3. Charge the battery cartridge with room
temperature at 10 ﾟ C - 40 ﾟ C (50 ﾟ F - 104 ﾟ F).
Let a hot battery cartridge cool down before
charging it.
4. Charge the battery cartridge once in every six
months if you do not use it for a long period of
time.

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before adjusting or
checking function on the tool.
Installing or removing battery cartridge
Fig.1
Open Garden Sprayer's battery pack cover.
•
Always switch off the tool before insertion or
•
removal of the battery cartridge.
To remove the battery cartridge, withdraw it from
•
the tool while sliding the button on the front of the
cartridge.
To insert the battery cartridge, align the tongue on
•
the battery cartridge with the groove in the housing
and slip it into place. Always insert it all the way
until it locks in place with a little click. If you can
see the red part on the upper side of the button, it
is not locked completely. Insert it fully until the red
part cannot be seen. If not, it may accidentally fall
out of the tool, causing injury to you or someone
around you.
Do not use force when inserting the battery
•
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Spray pipe and nozzle assembly method
1
2
1. Spray pipe
2. lever cock
3. Nozzle
010133
•
•
•
•
NOTE:
•
•
•
•
•
3
6
As shown in the figure, assemble spray pipe and
then nozzle onto lever cock.
Adjust direction of nozzle using nut on spray pipe.
Firmly attach components to ensure there is no
leaking.
Select nozzle according to type of spraying to be
done.
All connector units use packing. Before assembly,
always check to see that the units have packing.
Check to make sure that the spray hose is not
cracked, worn and/or damaged.
Firmly tighten on the spray pipe to prevent liquid
leaks.
If there is a leak from a connector unit, tighten
further using a hand tool (by approximately 45
degrees).
Do not use a spray pipe that is longer than the
standard one provided. Doing so may cause
leaking from connector units.