TG5421C_5422C_5423C(e).book Page 42 Friday, June 10, 2005 12:13 PM
Programmable Settings
Programming via direct commands
You can also program most features using "direct commands"—special codes that take
you directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit's menus.
Details of each feature can be found on the corresponding pages.
1
Press {MENU}.
2
Enter the desired feature code (shown below).
3
Enter the desired setting code (shown below).
L This step may vary depending on the feature being programmed.
4
Press {Save}.
5
Press {OFF} to exit programming mode.
Direct commands chart
Feature
Ringer volume
Ringer tone
*1*2
Interrupt tone
VM access
Voice enhancer
Copy phonebook
*1
(1 item)
Copy phonebook
*2
(1 item)
Copy phonebook
*1
(all items)
Copy phonebook
*2
(all items)
LCD contrast
Key tone
Auto talk
Set dial mode
42
Feature code
Setting code
{1}: Low {2}: Medium
{1} {1}
{3}: High {0}: Off
{1}–{3}: Tone pattern 1–3
{1} {2}
{4}–{7}: Melody pattern 1–4
{1}: On {2}: 2 times {0}: Off
{1} {3}
Go to step 2 on page 35.
{3}
{1}: On {0}: Off
{5}
Go to step 4 on page 24
{#} {1}
Go to step 4 on page 25
{#} {1}
{#} {2}
{1}–{3}: Extension 1–3
{#} {2}
{1}–{6}: Level 1–6
{0} {1}
{1}: On {0}: Off
{0} {2}
{1}: On {0}: Off
{0} {3}
{1}: Pulse {2}: Tone
{0} {5} {1}
Page
page 37
page 37
page 38
page 35
page 38
page 24
page 25
–
page 25
page 25
page 39
page 40
page 38
page 39