TG5571_5576_QG(e).fm Page 6 Thursday, February 3, 2005 6:08 PM
Programming via direct commands
You can program most features using "direct commands"—special codes that take you
directly to the feature you wish to program and allow you to select the desired setting.
There is no need to scroll through the unit's menus.
1
Press {MENU} (center of joystick), then press {#}.
Enter direct No.
:
2
Enter the desired feature code (shown below).
3
Enter the desired setting code (shown below).
4
Press {SAVE}.
5
Press {OFF} to exit programming mode.
Direct commands chart
Feature
Set dial mode
LCD contrast (Handset)
Ringer volume (Handset)
Ringer tone
Tone & Melody (Handset)
Talking Caller ID (Handset)
Auto talk
Ring count
Voice enhancer
Recording time
Call screening
Message alert
Ringer volume (Base unit)
Ringer tone (Base unit)
Talking Caller ID (Base unit)
Feature code
Setting code
{1}: Pulse {2}: Tone
{1} {2} {0}
{1}–{6}: Level 1–6
{1} {4} {5}
{1}: Low {2}: Medium
{1} {6} {0}
{3}: High {0}: Off
Scroll to "Tone & Melody", then
{1} {6} {1}
press {SELECT}.
{1}–{3}: Tone 1–3
{4}–{7}: Melody 1–4
{1}: On {0}: Off
{1} {6} {2}
{1}: On {0}: Off
{2} {0} {0}
{2}–{7}: 2–7 rings
{2} {1} {1}
{0}: Toll saver
{1}: On {0}: Off
{2} {7} {0}
{1}: 1 minute {2}: 2 minutes
{3} {0} {5}
{3}: 3 minutes {0}: Greeting only
{1}: On {0}: Off
{3} {1} {0}
{1}: On {0}: Off
{3} {4} {0}
{1}: Low {2}: Medium
{*} {1} {6} {0}
{3}: High {0}: Off
{1}–{3}: Tone 1–3
{*} {1} {6} {1}
{4}–{7}: Melody 1–4
{1}: On {0}: Off
{*} {1} {6} {2}
–
–
6