To Resume; To Vary The Speed Setting - Chrysler 2017 Pacifica Owner's Manual

Hide thumbs Also See for 2017 Pacifica:

Table of Contents

416 STARTING AND OPERATING

To Resume

If there is a set speed in memory push the RES (resume)

button and then remove your foot from the accelerator

pedal. The EVIC/DID will display the last set speed.

• If your vehicle stays at standstill for longer than two

seconds, then the driver will either have to push the

RES (resume) button, or apply the accelerator pedal to

reengage the ACC to the existing Set Speed.

• ACC cannot be resumed if there is a stationary vehicle

in-front of your vehicle in close proximity.

The Resume function should only be used if traffic

and road conditions permit. Resuming a set speed

that is too high or too low for prevailing traffic and

road conditions could cause the vehicle to accelerate

or decelerate too sharply for safe operation. Failure to

follow these warnings can result in a collision and

death or serious personal injury.

To Increase Speed

While ACC is set, you can increase the set speed by

pushing the SET + button.

Table of Contents