HP iPAQ HW 6955 Instruction Manual page 46

399310-xx1.book Page 42 Friday, December 16, 2005 3:52 PM
7. Select Install from a list or specific location, and then select Next.
8. Browse for location of the modem link.inf file on the Getting Started CD.
When the file is found, select it.
A message displays "This is an unassigned or unverified driver. Click
Continue Anyway on your personal computer.
9. Select Next to install the driver, and then select Finish.
10. Create a new modem connection on your personal computer.
11. Select To connect to the Internet, and then Next.
12. Select To set up manually, and then Next.
13. Select Connect using a dial up modem, and then select Next.
Use *99# for the phone number.
14. Select the default settings for the remaining setup options.
When the connection is established, click Connect or OK. If you are using
your HP iPAQ as a wireless modem, you do not need to enter a username
or password.
To start using Modem Link:
1. Tap Start > Accessories > Modem Link.
2. Tap menu > Activate.
3. When finished, tap Done.
NOTE Before setting up a serial port modem, an infrared, or USB connection,
be sure your HP iPAQ is not connected to another device.
To set up a serial port modem, an infrared, or USB modem connection:
1. Tap Start > Programs > Modem Link.
2. Tap Activate. (You should be using the USB drive for your connection.)
3. Connect your HP iPAQ to the cradle, and then to your personal computer.
Deactivate Modem Link on your HP iPAQ. Select Deactivate on the display
screen, and then remove the device from its cradle. Then reconnect it to the cradle.
NOTE When you are not using Modem Link, be sure to deactivate it. If not, you
will have problems using ActiveSync in the same session.
42