Disposal; Installation; Mounting - Hyundai H-SWE1-30V-UI065 Instruction Manual

Electrical instant water heater
mains. Perform cleaning or maintenance in accordance with the guidelines of this instruction
manual.
• Do not use hazardous chemicals for cleaning of the water heater and exclude their contact
with it.

Disposal

Upon expiration of service life, the water heater shall be disposed. For more details regarding
disposal of the water heater, please contact a representative of the local authorities.
Service life is about 10 years. Service life of the appliance is not equal to the warranty period.

INSTALLATION

During installation of the water heater, rigorously observe the laws, regulations, directives, and
standards (safety requirements, disposal rules/procedure, electrical safety rules, etc.) effective in
your country, as well as directives of local electrical energy/water suppliers.

Mounting

The electrical water heater shall be installed on a firm wall.
The wall planned for installation of the electrical water heater shall
be capable to bear at least double weight of the water heater fully
filled with water. The wall shall be free of cracks and other damages.
Otherwise, take measures to reinforce the mount or install the water
heater on a special support.
If the bathroom is too small, the water heater can be installed in
another place not exposed to direct sunlight and inaccessible for
moisture ingress. However for reduction of heat loss in pipes, the
installation place of the water heater shall be located as close as
possible to the hot water consumption point.
When selecting a location for the water heater, ensure free access
to it as follows: at least 60 cm between the bottom part of the water
heater and floor; at least 10 cm between the top part and ceiling.
This will ensure the maximum comfort for maintenance and adjust-
ment of the water heater, when necessary.
After you have selected the proper place for installation of the water
heater, mark points to make holes for the anchor bolts with hooks.
Drill two holes of appropriate depth in the wall using a drill with suit-
able size for the anchor bolts provided in the water heater package.
After that, insert the bolts to the drilled holes and rotate the hooks
of the bolts clockwise to securely tighten the nuts of the bolts. Then,
hang the water heater onto the hooks of the anchor bolts and check
security of mounting.
CAUTION!
Refer to «Water heater safe operation and installation rules»
9.
EN