Clevo W330SU2 Service Manual page 34

Disassembly
5. Insert a new module holding it at about a 30° angle and fit the connectors firmly into the memory slot.
Figure 6
6. The module will only fit one way as defined by its pin alignment. Make sure the module is seated as far into the slot
RAM Module
as it will go. DO NOT FORCE IT; it should fit without much pressure.
Removal (cont'd)
7. Press the module in and down towards the mainboard until the slot levers click into place to secure the module.
8. Replace the bottom case and tighten the screws and cover
d. Replace the bottom
9. Restart the computer to allow the BIOS to register the new memory configuration as it starts up.
case and tighten the
screws.
2 - 10 Removing the System Memory (RAM)
d.
(Figure 6d) .