12.
Inserting/Connecting the Flight Battery
Attention, important!
Before connecting the flight battery to the model, the remote control transmitter must be taken into operation.
Observe that the transmitter is set to the mode desired by you and the control lever for the motor function is
in the bottom position.
Install the flight battery (1) centrally on the RC board (2) and connect them to the model electronics with the plug
connector (3) that is protected against polarity reversal.
After approx. 2 seconds, a red LED lights up on the model electronics and signals readiness for operation of the
model.
The rudder and elevator, as well as the motor react to the movements of the control levers at the transmitter now.
Figure 8 shows the receiver aerial (4). Observe that the aerial does not block the control mechanism in flight operation
or protrude into the RC box.
If the LED is not lit, the transmitter may not be switched on or not recognised by the receiver (see next
chapter 13).
If the LED flashes slowly, either the control lever for the motor function is not correctly pushed to the bottom
position or the throttle function trimming is set too high.
Figure 8
41