Assembly - NordicTrack NTL2295.0 User Manual

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed.
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench
standard screwdriver
ware, see the hardware drawings below. To avoid damaging plastic parts, do not use power tools for as-
sembly.
Star Washer (67)–12
Short Console
Bolt (112)–2
Console Bolt (72)–2
1. With the help of a second person, tip the Upright (20)
down as shown. Next, slide the treadmill out of the box.
Attach the four Base Pads (81) and two Pad Spacers (A)
to the bottom of the Upright (20) with the four 1" Tek
Screws (82) in the locations shown.
Thread the two Leveling Feet (130) into the bottom of the
Upright (20).
Insert the three Cage Nuts (128) into the three indicated
holes in the treadmill. To insert each Cage Nut, first hook
one side of the Cage Nut into a hole. Then use a stan-
dard screwdriver to press the other side of the Cage Nut
into the hole, as shown
and your own phillips screwdriver
and wire cutters
Cover Screw (90)–2
Base Plate Bolt (125)–3
6
. For help identifying the assembly hard-
1" Tek Screw (82)
Handrail Bolt (66)–4
Pulse Bar Bolt (13)–4
1
82
37
82
81
130
82
128
128
,
81
37
20
130