Table of Contents
Advertisement
OptiFlow™ Vertical Power Stacker
Adjusting Stacker Wall
•
Grasp the stacker wall from top and slide up or down to an ap-
propriate position. Use the knob on rear to tighten wall into place.
Stacker
Wall
NOTE: It is possible that envelopes at the bottom of the stack
could deform as stack weight increases. If this is a problem, set
the height of the stacker wall to a lower position.
Unloading Material
•
Lift material from top of stack. Do not overfill hands to the point
where they are in a strained or unnatural position.
NOTE: You can remove material from the stack while the stacker
is running. The stacker will run as long as the stack-full sensor is
not blocked for more than 1/2 second.
Stack Full
Sensor
Full Height Position
Knob
SV61322 Rev. C
Advertisement
Table of Contents
