Clearing Stalls In A Stacker Attached To A Di900/Di950 - Pitney Bowes OptiFlow DIVS Operator's Manual

Clearing Stalls in a Stacker Attached to a DI900/950
1. Push the stacker release lever UP.
2. Open the stacker as shown be-
low and at the right. It's hinged
on one side. Clear all stalled
material from the stacker.
3. Close the stacker.
4. Push the stacker release
lever DOWN to lock the
stacker in place.
SV61322 Rev. C
Operator Guide
5. Resume operation as fol-
lows:
a. Double check that you
have cleared all stalled
material.
b. Press the START but-
ton on the inserter's
control panel.
NOTE: Some stacker faults
may require you to press the
stacker's RESET switch to
resume normal operation. See
the error messages listed on
page 11. The reset switch is
shown on page 5.