Fortinet FortiCam FD40 Quick Start Manual page 11

To connect
Open the dome cover.
1.
2. To use the back conduit entry, remove the entry block with a coin and
screw it to the side entry.
3. To use the side conduit entry, insert the Ethernet cable through
the cable gland and install the gland to the side entry. Seal the
unused gland cable opening with the supplied plug. Note that the
side and back openings are compatible with 3/4" EMT conduit.
4. Connect the camera to a FortiRecorder NVR via a PoE switch. The
camera gets its IP address from the DHCP server automatically.
Note: The camera's fallback IP address is 192.168.1.245.
After you have connected the camera to the FortiRecorder NVR, you
can start to configure the camera settings from the FortiRecorder
side. For details, see the FortiRecorder Administration Guide on
http://docs.fortinet.com.
Page 11