Makita HR2610 Technical Information page 18

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-9. How to assemble Gear housing to Inner housing
(1) Check that Clutch cam A is engaged with Swash bearing 10. (Fig. 50)
(2) Assemble Compression spring 4 and Lock plate to Gear housing
complete. (Fig. 51)
Note: Apply grease to the end of Compression spring 4 on Lock plate
mating side in order to do the next step smoothly.
(3) While holding Lock plate by a finger so as not to drop from the guide
of Gear housing complete, Assemble Gear housing complete to
Inner housing complete. (Fig. 52)
Fig. 51
guides of Gear housing
complete for Lock plate
Compression spring 4
Lock plate
Fig. 50
Swash bearing 10
Clutch
cam A
Check here.
Fig. 52
Lock plate
P 18/ 22