Makita HR2610 Technical Information page 15

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-6. Impact bolt section in Tool holder complete for HR2610/ HR2610F
Tool holder guide complete for HR2610T/ HR2611FT (cont.)
(2) Push Ring spring 28 into the inner groove of Tool holder (guide) complete as drawn in Fig. 41.
Note: Do not reuse the removed Ring spring 28 if it is deformed or damaged.
Fig. 41
Piston cylinder
as a jig
end gap
Ring spring 28
Tool holder
(guide) complete
hole
Note: 2
Tool holder
(guide) complete
Ring spring 28
end gap
Note: 1. Use an extra Piston cylinder as a jig. Never use Piston cylinder that is to
be assembled to the machine.
2 The end gap of Ring spring 28 must not be located at the two holes of
Tool holder (guide) complete.
Note: 1
Inner groove of
Tool holder (guide)
complete
hole
Ring spring 28
[Correct] [Wrong]
Piston cylinder as a jig
(HR2610)
P 15/ 22
O ring case A