Makita HR2610 Technical Information page 12

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-5. Torque limiter section
DISASSEMBING
(1) Remove Bit holder section (HR2610, HR2611F) / Holder section (HR2610T, HR2611FT).
(2) Remove Change lever section.
(3) Separate Gear housing complete from Motor housing complete.
(4) Remove Tool holder complete (HR2610, HR2611F) / Tool holder guide complete
(HR2610T, HR2611FT) by tapping the top as drawn in Fig. 31.
Note: Flat washer 30 is located between Tool holder (guide) complete and Inner housing
complete. Be careful not to lose it.
(5) Set 1R045 and 1R369 to Tool holder (guide) complete. (Fig. 32)
(6) Compress Compression spring 32 (Fig. 33), then separate Spiro lock washer 30 from
Tool holder (guide) complete by sliding a thin slotted screwdriver from the upper end
as drawn in Fig. 34. The components are disassembled. (Fig. 35)
Fig. 32
Tool holder (guide) complete
1R369
Fig. 37
Tool holder
(guide) complete
Steel ball 4
Driving flange
(4 pcs.)
Spur gear 51 Flat washer 30 (thicker than the others)
Pin 6
(6 pcs.)
Fig. 33
1R045
Compression spring 31
Compression spring 31
Fig. 31
Fig. 34
Upper end of
1R369
Spiro lock
washer 30
thin
slotted
screwdriver
Flat washer 30 (thin)
Spiro lock washer 30
P 12/ 22
Tool holder
(guide)
complete
1R369