Makita HR2610 Technical Information page 16

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3]-7. Swash bearing section
DISASSEMBLING
(1) Disassemble Motor housing section, Gear housing section and Inner housing section. As for HR2610F and HR2611F,
remove two M4x12 Hex socket head bolts. And then separate Counter weight section from Inner housing complete.
(Fig. 43)
(2) Remove two M4x16 Hex socket head bolts with hex wrench 3 and 1R228. (Fig. 44)
Then pull Swash bearing section out of Inner housing complete. (Fig. 45)
(3) Remove Ball bearing 606ZZ from Gear housing complete using the removed Swash bearing section. (Fig. 46)
(4) Remove Stop ring E-6 from Can shaft, then separate Flat washer 7, Spur gear 10 and Clutch cam A from Can shaft.
Receive Swash bearing 10 on 1R034 and press out Cam shaft with Arbor press.
The swash bearing section can be removed as drawn in Fig. 47.
Fig. 43
For HR2610F and HR2611F
only
Pin 6
Weight holder guide
Fig. 45
Inner housing complete
Piston cylinder
Push Piston cylinder into Inner housing
complete to tilt Swash bearing 10.
Fig. 46
Insert shaft portion of Spur gear 10
to the hole of Ball bearing 606ZZ,
and tilt it either backward or
forward.
Fig. 47
Stop ring E-6 Spur gear 10 Clutch cam A
Flat washer 7
Fig. 44
M4x12 Hex socket
head bolt (2 pcs.)
Plate
Counter weight
Note: These are thread
Swash bearing 10
Swash bearing section
(Note: Ball bearing 606ZZ is left in Gear housing complete.)
Tap Gear housing complete with plastic hammer.
Ball bearing 606ZZ is removed together with
Swash bearing section.
Ball bearing 606ZZ
in Gear housing
complete
Swash bearing 10
Cam shaft Flat washer 8
M4x16 Hex socket
head bolt (2 pcs.)
locking screws.
Do not reuse them without applying
ThreeBond 1321B/ 1342 or Loctite 242..
Pull Swash bearing section horizontally
with Swash bearing 10 kept tilted, and
remove the pole of Swash bearing 10
toward the tilted direction.
Ball bearing 606ZZ
Bearing box Ball bearing 608ZZ
Bearing retainer
P 16/ 22
Helical
gear 26