Hotpoint E3D AA X Operating Instructions Manual page 23

a) The alarm sounds.
• The refrigerator door has remained open for more than two
minutes (the buzzer will stop sounding when you shut the door) or the
correct switching-off procedure was not followed ( see Maintenance ).
b) The alarm sounds and the two blue indicator lights flash.
• The temperature in the freezer is too high. Check the quality of
the food products and dispose if necessary.
+ buzzer =
Heating is excessive
c) The alarm sounds and the two blue indicator and green
one lights flash.
• The temperature in the freezer has reached a dangerous level.
The food must be disposed immediately.
+ buzzer = Heating danger
b/c) In both these cases the freezer will maintain a temperature of
about 0°C so that the food does not re-freeze.
To turn off the acoustic signal open and close the refrigerator door.
restore normal operation product should be switched off and switched
on by buttons from control panel (See the description)
The refrigerator and the freezer do not cool well.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The refrigerator or the freezer have been over-filled.
The food inside the refrigerator is beginning to freeze.
• The temperature is not adjusted properly (see description)
• The food is near the back inside wall of the refrigerator.
The motor runs continuously.
• The SUPER FREEZE button has been pressed (rapid freezing):
the blue SUPER FREEZE light is on ( see Description ).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
The appliance makes a lot of noise.
• The appliance has not been installed on a level surface ( see
Installation ) .
• The appliance has been installed between cabinets that vibrate
and make noise.
• The internal refrigerant makes a slight noise even when the
compressor is off. This is not a defect, it is normal.
GB
23