Push Button Configuration (Pbc) - ZyXEL Communications WRE6505 User Manual

• PIN Configuration - create a secure wireless network simply by entering a wireless client's PIN
(Personal Identification Number) in the WRE6505's interface. See
is the more secure method, since one device can authenticate the other.

8.3.1 Push Button Configuration (PBC)

The push button configuration function found in the interface is only available in AP mode. The WPS
button, see
mode.
Make sure that your WRE6505 is turned on and set to work in AP mode and that it is connected to
1
your network.
Launch your wireless client's configuration utility.
2
In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Start or
3
WPS button).
Log into WRE6505's Web Configurator. Make sure WPS is enabled in the Network > Wireless LAN
4
> WPS screen.
Navigate to Network > Wireless LAN > WPS Station and press the Push Button.
5
Note: Your WRE6505 has a WPS button located on its panel, as well as a WPS button in
its configuration utility (AP mode only). Both buttons have exactly the same
function; you can use one or the other.
Note: It doesn't matter which button is pressed first. You must press the second button
within two minutes of pressing the first one.
The WRE6505 sends the proper configuration settings to the wireless client. This may take up to
two minutes. Then the wireless client is able to communicate with the WRE6505 securely.
The following figure shows you how to set up wireless network and security by pressing a button on
both WRE6505 and wireless client (the NWD-211AN in this example).
Section 1.3 on page 9, can also be used for PBC configurations in either AP or Repeater
WRE6505 User's Guide
Chapter 8 Tutorials
45
Section 8.3.2 on page 46. This