2. risk of Electrical Shock: 7. For proper automatic operation, General make sure the pump power connect only to a properly cord is plugged into the Information ground ed receptacle. piggyback receptacle on the Septic tank to be vented in diaphragm switch cord.
b. pump motor or bearings power cord from terminals in Pump may be defective control panels (manual pump models) and power source Servicing c. start capacitor in motor may (automatic models) and remove have failed pump from sump. read the following instructions d.
Page 5
To check the from RESISTANCE seals, remove the lower housing SPD50H SPD100H terminal bushings on top of pipe plug (#8) and pour the oil 1ø Start 1ø Main 3ø Bal. 1ø Start 1ø Main 3ø Bal.
Page 6
6. Turning the bearing by hand: do not roll it. if twisted, Pump if it feels rough when turned water may enter chamber and or looks rusted, it should be cause failure. Servicing replaced. obtain a bearing 7. clean the motor housing puller to remove the bearing.
Page 7
note: Too much pressure leaks, fill the motor and plugs (#6). Turn pump on side will damage the seal. seal housing with high grade and fill seal chamber to 1" trans form er oil, such as Sohio from top. replace plug (#8) Factopure SE40 or equiv a lent, and stand pump up.
4. Pump head may be too 1. inlet in pump base may be high. Pump cannot deliver water over (SPd50H) 50' or clogged. remove pump and clean out open ings. (SPd100H) 64' vertical. Pump must be sized to 2.
Page 10
SPD50H/100H Three Phase 3-PHASE WIRING LOW VOLTAGE (230V) HIGH VOLTAGE (460V) 29 30 13 11 MODEL – SPD50H/SPD100H THREE PHASE Ref. No. Part No. Description Qty. Ref. No. Part No. Description Qty. 60-000-5 Handle 324-001-1 Gasket 56-023-2 Housing, Motor 19103A052 Screw, Hex Hd.
Violet (9) 230V LINE Yellow (3) Black (6) Blue(4) Brown (10) Violet (9) 115V LINE Yellow (3) Black (6) Blue(1) MODEL – SPD50H/SPD100H SINGLE PHASE Ref. SPD50H SPD100H Ref. SPD50H SPD100H Part No. Part No. Description Qty. Part No. Part No.
Limited Warranty HYDROMATIC warrants to the original consumer purchaser (“Purchaser” or “You”) of HYDROMATIC Sump Pumps, Effluent Pumps, Sewage Pumps (other than 2-1/2”), and Package Systems, that they will be free from defects in material and workmanship for the Warranty Period of 36 months from date of manufacture. Our warranty will not apply to any product that, in our sole judgement, has been subject to negligence, misapplication, improper installation, or improper maintenance.