Table of Contents
Advertisement
Remote Control Battery Installation And Replacement
The remote control is powered by two 1.5V AAA
batteries installed at the factory.
To install or replace batteries:
1. Remove the battery module of the remote
control by removing the two screws on the
end of the battery module. Slide the battery
module out of the remote control.
2. Insert two new "AAA" size batteries into the
battery module.
3. Slide the battery module back into the remote
control and reinserting the two screws in the
end of the battery module.
CAUTION
Incorrect usage of batteries can result in leaks
or bursting. Peerless-AV recommends the
following battery use:
1. Do not mix battery brands.
2. Do not combine new and old batteries. This
can shorten the battery life or cause liquid
leakage of the batteries.
3. Remove dead batteries immediately to
prevent battery acid from leaking into the
battery compartment.
4. Do not touch exposed battery acid as it
may injure skin.
5. Remove the batteries if you do not intend
to use the remote control for a long period
of time.
Power On/Off Your New Display
Power on your display by using the remote control or the rear power key as shown below. The display
will power on but image may not appear for a few seconds as it completes it's power up sequence.
Remote control
Point the remote control at the IR sensor located
in the upper right corner of the display and press
the power key.
Rear Power Key
10
2014-06-13
#:220-9001-5
(2016-03-02)
Advertisement
Table of Contents
