Sony SRS-XB2 Help Manual page 70

Hide thumbs Also See for SRS-XB2:

Table of Contents

Adjust the volume by pressing the –/+ (volume) buttons on the speaker or operating the BLUETOOTH

mobile phone.

When you press the –/+ (volume) buttons on the speaker or adjust the volume on the BLUETOOTH mobile phone, the

(power) indicator flashes once in green. When you set the volume to the maximum or minimum, the

flashes three times in green.

To end a call, press the

If you were listening to music before the call, playback will resume when the call ends.

If you end a call by operating the BLUETOOTH mobile phone, playback will also resume when the call ends if you were

listening to music before the call.

Hint

The volume of music playback and calling is set independently in the speaker.

If the caller cannot hear or can barely hear your voice, talk more directly into the microphone of the speaker.

Note

When using the Speaker Add function, sound of the phone call is output from only the speaker where the

The sound is output from the right speaker only during a call.

Depending on the BLUETOOTH mobile phone, playback may not pause when making a call.

Use a BLUETOOTH mobile phone at least 50 cm away from the speaker. Noise may result if the speaker and the BLUETOOTH mobile phone are

too close.

When an audio cable is connected to the AUDIO IN jack of the speaker, you cannot listen to music of the BLUETOOTH device. However, when

the BLUETOOTH connection is active, the hands-free function is available.

Table of Contents