Sony SRS-XB2 Help Manual page 36

Hide thumbs Also See for SRS-XB2:

Table of Contents

Check that the

When the speaker is connected to the computer, the

from your computer.

If a connection cannot be made, despite [SRS-XB2] appearing on the screen, initiate pairing mode on the speaker.

Press and hold the

to flash quickly in white.

Hint

For details on operating your computer, refer to the operating instructions supplied with the computer.

Note

The pairing mode of the speaker is released after about 5 minutes and the

information is not stored in the speaker, such as at the factory settings, the pairing mode is not released. If the pairing mode is released before

finishing the process, repeat from step 2.

Once the BLUETOOTH devices are paired, there is no need to pair them again, except in the following cases:

Pairing information has been deleted after repair, etc.

The speaker is already paired with eight devices and another device is to be paired.

The speaker can be paired with up to eight devices. If a new device is paired after eight devices have already been paired, the paired device

with the oldest connection time is replaced by the new one.

When the pairing information of the speaker has been deleted from the BLUETOOTH device.

When the speaker is initialized, all the pairing information is deleted.

The speaker can be paired with multiple devices, but can only play music from one paired device at a time.

When an audio cable is connected to the speaker's AUDIO IN jack while the speaker and the BLUETOOTH device have been connected via

BLUETOOTH connection, sound from the BLUETOOTH-connected device is not output from the speaker (the hands-free function is available). To

listen to music from the BLUETOOTH device, disconnect the audio cable from the speaker's AUDIO IN jack.

Table of Contents