NordicTrack NTSA03991 User Manual page 8

Cable Assembly
8. Open the parts bag labeled "CABLE ASSEMBLY."
Attach the Cable (133) to the indicated hole in the
Press Base (101) with a 3/8" x 3" Bolt (117), two 3/8"
Washers (120), a 5/8" x 1/4" Spacer (127), and a 3/8"
Nylon Jam Nut (122). Do not over tighten the Nylon
Jam Nut; the Cable must be able to pivot easily.
9. Wrap the Cable (133) up around a 4" Pulley (113) and
attach the Pulley and a Cable Trap (116) to the Rear
Press Upright (104) with a 3/8" x 3 3/4" Bolt (110), a
3/8" Washer (120), and a 3/8" Nylon Locknut (118).
Make sure the Cable is routed in the direction
shown.
10. Wrap the Cable (133) under a 4" Pulley (113) and
attach the Pulley and a Cable Trap (116) to the Base
Frame (101) with a 3/8" x 3 3/4" Bolt (110), a 3/8"
Washer (120), and a 3/8" Nylon Locknut (118). Make
sure the Cable is routed in the direction shown.
11. Insert the end of the Cable (133) between the 4"
Pulley (113) and the Cable Trap (116) assembled in
step one.
8
120
120
117
9
120
118
10
101
118
120
11
133
116
113
8
122
127
133
101
110
113
133
116
104
110
113
116
133