Table of Contents
Advertisement
THE CUTTING T BLE
The heavy-duty cutting table provides the durability to
handle large materials. Figure 3.
WARNING: Only use the 14" diameter blade
for this saw. Setting smaller size of diamond blade
may grab the material being cut, causing damage
and possibly injury.
STEPS TO USE THE 45˚ / 90˚ RIP
GUIDE
1. Set the rip guide by positioning it on the
desired dimension and tighten the threaded
knob. Make sure that the rip guide is firmly
tightened to avoid slippage. The rip guide can
be used 90˚ rip cugts and 45˚ angle cuts from
both the left and right side.
straight and 45˚ angled slits on the bottom of
the rip guide.)
2. After the rip guide is positioned for the
desired cut, place material flat against the rip
guide and the measurement rail. For the 45˚
rip cuts, place the corner of material in the
open slot of the measurement rail.
3. Simply line up the material being cut with the
appropriate pre-marked lines on the cutting
table.
4. Now you are ready to make your cut.
CUTTING DEPTH
The recommended cutting depth is 1/4" below the
cutting table surface. When setting the cutting depth,
do a practice pass with the table to make sure the
blade does not cut into it.
Blade Diameter
14"
Figure 3
(Note: The
Cutting Depth
5 inch
– 7 –
WARNING: It is recommended to cut all the
way through the material being cut. Failure to do
so can result in the diamond blade grabbing the
material causing damage and possibly injury.
THE SPRING LOCK PIN
The VX141MS Masonry Saw is designed with three
different cutting heights for jam cutting, a moving
head for chop (or plunge cutting), and a moving cart
combined with the moving head for step cutting to
help make any cutting task easier.
1. Before adjusting the cutting depth always
disconnect the electrical power supply.
2. To adjust the saw's fixed cutting position, pull
up on the Angle Lock Pin, Figure 4, move the
head to the new position, release the Angle
Lock Pin, and rotate the cutting head
up/down until the Angle Lock Pin lokcs into
position (lowest position for cutting thru
bricks). The middle position is for cutting
block and the upper position for blade
replacement.
CHOP / PLUNGE S W
OPER TION
To operate the VX141MS as a chop or plunge saw:
pull up on the Angle Lock Pin, rotate 90 degrees, and
release. Now the cutting head can be rotated by
pulling up or pushing down on the cutting head
handle. When not in use, always lock the head into
one of the three cutting height positions.
HEAD POSITION
Fixed Lowest
Fixed Middle
Fixed Upper
Moving
Moving head with
moving table
Angle
Lock Pin
Figure 4
APPLICATION
Jam cutting bricks
Jam cutting block
Diamond blade replacement
Chop or Plunge Cutting
Step cutting
Advertisement
Table of Contents
