NordicTrack NTHK22490 User Manual page 7

4. Place a Handrail Cover (51) on each Upright (65). Make
sure that the Handrail Covers are turned as shown in the
inset drawing.
Have a second person hold the Handrail (50) in the posi-
tion shown. Connect the Handrail Wire Harness (60) to
the Upright Wire Harness (63) and insert both Wire
Harnesses into the right Upright (65).
Hold a Metal Spacer (122) inside the right Upright (65)
and align it with the first hole in the Upright. Insert a
Handrail Bolt (53) with a Handrail Star Washer (52)
through the Upright and the Spacer. Hold the Handrail
(50) near the Handrail Covers (51) and finger tighten the
Handrail Bolt into the Handrail. Repeat this procedure on
the other side. Then, tighten the two remaining Handrail
Bolts with Handrail Star Washers into the Handrail. Be
careful not to pinch the wires.
Tighten all of the bolts used in steps 3 and 4. Press the
Large Endcaps (121) into the Uprights (65).
5. Make sure that all parts are tightened before you use the hiker. Keep the included allen wrench in a secure
place. The allen wrench is used to adjust the walking belt (see page 25). To protect the floor or carpet from
damage, cover the floor under the hiker.
4
121
51
53
65
50
51
65
7
122
52
122
60
63
65
50
121
51
52
53