NordicTrack NTBE06900 User Manual page 8

6. Press a 2 1/2Ó Square Inner Cap (28) into the Left
Frame (12). Attach the Left Frame to the left
Uprights (7, 8) using four 3/8Ó x 3 1/2Ó Bolts (31)
and four 3/8Ó Nylon Locknuts (29). Do not tighten
the Nylon Locknuts yet.
Assemble the Right Frame (10) to the right Uprights
(7, 8) in the same manner.
Attach the Center Frame (11) to the Left Frame (12)
and the Right Frame (10) using four 3/8Ó x 3 1/2Ó
Bolts (31) and four 3/8Ó Nylon Locknuts (29).
Tighten all Nylon Locknuts used in steps 1Ð6.
7. Press the two 2Ó Round Inner Caps (42) into the
weight tubes on the Weight Carriage (15).
Make sure the Weight Carriage is turned so the
weight tubes are near the top, as shown. Attach
the lower Carriage Bushing using a 3/8Ó x 2 1/2Ó
Bolt (35), two 3/8Ó Washers (37), the 2Ó Spacer
(39), and a 3/8Ó Nylon Jamnut (48).
8. Set the two Weight Bumpers (18) over the indicated
holes in the Weight Guide Base (4). Hold the
Weight Carriage (15) on top of the Weight
Bumpers.
Insert the two Weight Guides (9) into the Weight
Carriage (15), the Weight Bumpers (18), and the
Weight Guide Base (4). Attach the Weight Guides
using two 5/16Ó x 4Ó Bolts (49), four 5/16Ó Washers
(36), and two 5/16Ó Nylon Locknuts (30).
9. Press a 2 1/2Ó Square Inner Cap (28) into the end
of the Weight Guide Frame (14). Wipe the lat bar
rests on the Weight Guide Frame with lubricant.
Slide the Lat Bar Rest Covers (47) onto the lat bar
rests.
Hold the Weight Guide Frame (14) on top of the
Center Frame (11) and the Weight Guides (9).
Attach the Weight Guides to the Weight Guide
Frame using two 5/16Ó x 2Ó Bolts (33), four 5/16Ó
Washers (36), and two 5/16Ó Nylon Locknuts (30).
Attach the Weight Guide Frame (14) to the Center
Frame (11) using two 3/8Ó x 3 1/2Ó Bolts (31), two
3/8Ó Washers (37), and two 3/8Ó Nylon Locknuts
(29).
6
10
31
7
7
42
48
37
16
8
9
31
14
47
47
37
29
8
11
29
31
8
12
31
31
7
29
15
Weight Tube
42
39
37
35
9
15
30
18
36
30
36
11
9
29
28
29
8
4
36
49
28
33