NordicTrack NTBE06900 User Manual page 7

3. Tap a 2 1/2Ó Square Inner Cap (28) into each of the
Front Uprights (7).
Attach one of the Front Uprights (7) and two Joint
Plates (6) to the Left Base (3) using four 3/8Ó x 3
1/2Ó Bolts (31) and four 3/8Ó Nylon Locknuts (29).
Make sure the Front Upright is oriented so that
the holes on the bottom of the Front Upright
and the holes in the Joint Plates line up. If they
do not line up, turn the Front Upright upside-
down. Do not tighten the Nylon Locknuts yet.
Make sure the Front Upright is turned so the
adjustment holes are facing the Rear Upright
(8).
Attach the other Front Upright (7, not shown) and
two Joint Plates (6, not shown) to the Right Base
(1) in the same manner.
4. This step will require two people.
Refer to drawing 4a. Have one person hold out the
Adjustment Knobs (22) on a Safety Spotter (20),
while the other person slides the Safety Spotter
down over the right Uprights (7, 8), as shown. Hold
the Adjustment Knob out on the Weight Rest (19),
and slide the Weight Rest onto the Front Upright
(7). To avoid breaking the Square Bushings (21)
inside the top and bottom of the Safety Spotter
and Weight Rest, be careful not to catch the
Square Bushings on the edges of the Uprights
as they slide on.
Refer to drawing 4b. Secure the Safety Spotter (20)
and the Weight Rest (19) to the right Uprights (7, 8)
by snapping the three Adjustment Knobs (22) into
adjustment holes in the Uprights and turning them
clockwise until tight.
Assemble the other Safety Spotter (20) and Weight
Rest (19) to the left Uprights (7, 8) in the same
manner. Make sure both Safety Spotters and
both Weight Rests are at the same height.
5. Attach the Chin-up Bar (13) and two Joint Plates (6)
to the Front Uprights (7) using four 3/8Ó x 3 1/2Ó
Bolts (31) and four 3/8Ó Nylon Locknuts (29). Do
not tighten the Nylon Locknuts yet.
3
1
31
6
4a
21
19
22
21
20
22
21
8
7
5
6
29
7
7
28
8
7
Adjustment
Holes
29
3
29
6
4b
7
8
22
19
20
22
13
31
31
7
6
29