NordicTrack FUTURA NTS78740 User Manual page 16

ADJUSTING THE SEAT
The Seat (45) can be secured at various positions on
the Rail (4). To move the Seat, pull the Seat Knob
(48) out as far as it will go and slide the Seat to the
desired position. Engage the Seat Knob into an
adjustment hole in the Rail.
To perform row exercises, the hip strap must be
attached to the mech cable (see ATTACHING THE
ACCESSORIES, on page 14), and the Seat Carriage
(44) must be able to roll along the Rail (4). First,
remove the Backrest (35) from the Seat Carriage (see
ADJUSTING THE BACKREST on page 15). Then,
pull the Seat Knob (48) out as far as it will go, and
turn the Knob so that the pin rests at the end of the
"L"-shaped slot (see the inset drawing).
STORING THE RESISTANCE SYSTEM
To store the resistance system, first remove the Curl
Pad (not shown) and the Leg Lever (not shown) from
the resistance system. Secure the Seat Carriage (44)
at the position closest to the Leg (5) (see ADJUSTING
THE SEAT above). Next, remove the Storage Knob
(29) from the Row Plate (28). Lift the Leg toward the
Top Frame (37), and tighten the Storage Knob into the
side of the Row Plate and into the Rail (4).
To move the resistance system, stand behind the
Upright (2) and place the toe of your shoe on the end
of the Base Plate (1) and hold the resistance system
in the indicated area. Tilt the resistance system back
onto the Wheels (65) and roll it to the new location.
WARNING:
Storage Knob (29) is in place and fully tight-
ened each time the resistance system is used.
Make sure that
4
Adjustment
Hole
5
44
28
16
35
45
44
48
Pin
"L"-Slot
37
Hold in
this area
2
4
29
1
44
48
65