Treadmill Will Stop And Reset - Horizon Fitness 1.1T Service Manual

• Check voltage of wall outlet.
Warning! Hazardous voltages will be tested in the following procedure. Exercise
extreme caution when performing these procedures. Do not connect or disconnect
any wiring, connectors, or other components with the power applied to the treadmill.
• Disconnect the treadmill power cord from the wall outlet. Using an AC voltmeter,
verify that the proper AC voltage is present at the wall outlet. Nominal 120 Vac
may vary between approximately 105 Vac and 135 Vac. If the AC voltage is
missing or incorrect, check the AC service or consult an electrician.
• Make sure that the treadmill is connected to a dedicated 20amp circuit, with out the
use of an extension cord.
• Verify all wire connections for proper connection, including power cord.
• Inadequate lubrication on deck and belt. Refer to treadmill lubrication
procedures.

Treadmill Will Stop and Reset

41