PART IDENTIFICATION CHART
See the drawings below to identify small parts used in assembly. The number in parentheses by each drawing is
the key number of the part, from the PART LIST on page 10. Note: Some small parts may have been pre-
assembled. If a part is not in the parts bag, check to see if it has been preassembled.
M6 Washer (22)
M10 x 15mm Screw (21)
ASSEMBLY
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the dumbbell bench, make sure
that all parts are oriented as shown in the draw-
ings.
M10 Washer (23)
M10 x 25mm Bolt (17)
M10 x 90mm Bolt (18)
M10 x 193mm Bolt (19)
M10 Nylon
Locknut (24)
M10 x 65mm Screw (20)
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
In addition to the included hex key
packet, assembly may require the following
tools (not included):
• one standard screwdriver
• one Phillips screwdriver
• one adjustable wrench
• one rubber mallet
5
M6 x 50mm Screw (16)
and grease