Harmar Mobility Pinnacle E SL600E Owner's Manual page 6

Pinnacle E
Stairlift operation (cont.)
Step 4: If you release the control switch the lift will stop. Continue to press the switch or button all the
way to the landing. The lift will gently stop at the appropriate, pre-set point.
Step 5: To safely exit the lift, support yourself by the armrests, rise and step off the footrest. At the upper
landing, ensure that the seat is fully swivelled and locked before rising. If you do not intend to use the lift
again immediately the seat and armrests may be folded up to minimise obstruction to people walking on
the stairs.
When transferring in or out of the seat
use the armrests to assist you. Ensure
the seat is securely latched before
WARNING
transferring in or out.
Step 6: To operate the lift remotely, continuously press the appropriate up or down button on the call/
send hand control unit. These hand control units are usually attached to a wall at the upper and lower
landings of the staircase. Like all infra-red devices, the signal may be interrupted if the hand control unit is
not in the line of sight of the stairlift. If this happens the lift may temporarily stop but restart immediately,
as long as the hand remote is pressed continuously.
If you are operating the lift remotely on behalf of another person, please ensure that they are securely
seated with the seat belt engaged. Always keep the person in line of sight before commencing
movement.
NOTE: An amber light and single beep indicate that the lift has touched an obstruction and may only
be operated in the opposite direction of the obstruction. Clear the obstruction before proceeding.
If the light fl ashes orange and the lift beeps intermittently, the lift has been stopped away from the top
or bottom charging stations. Please move the lift to either end of the rail to ensure the batteries remain
fully charged.
The LED indicator light will turn red if there is a service issue. Turn the "ON/OFF" switch to the "OFF"
position (O) and then back to the "ON" position (I). The lights should sequence red-amber-green. If the
light does not return to green, please call your service representative.
6
OPERATION
| www.harmar.com © 2015 Harmar Mobility, LLC • All rights reserved