Daikin FXAQ20PVE Installation Manual page 8

(4) Remove the front panel and the service cover. (Refer to Fig. 5)
< How to remove the front panel and service cover >
(1) Open the front panel to the point where it stops.
(2) Push the axes on either side of the front panel towards the center of the main unit and remove. (You can
also remove it by sliding the front panel either to the left or right and pulling it forward.)
(3) Remove the screw from the service cover and pull the handle forward.
(5) Point the pipe in the direction it will be passed out.
For right, bottom-right, and back-right piping (Refer to Fig. 6)
• Wrap the drain hose and the refrigerant piping together with the insulat-
ing tape (4) so that the drain hose is below the refrigerant piping.
For left, bottom-left, and left-back piping
• Remove the front grille. (Refer to Fig. 7)
< How to remove the front grille >
Remove the front grille as described below when securing the indoor
unit with screws or when attaching Optional Accessories (wireless
remote controller, adapter PC board, etc.).
(1) Remove the front panel.
(2) Remove the screws (2 places in case of FXAQ20,25,32 type/3 places in case of FXAQ40,50,63 type)
securing the front grille.
(3) Remove the tabs (3 places) securing the front grille by pushing them in the direction of the arrows.
(4) Making sure not to catch the horizontal flaps, remove the front grille by pulling in the direction of the
arrow.
(3)
(2)
• Remove the drain plug, the insulation tubing, and the drain hose from the drain pan and replace.
(Refer to Fig. 8)
• Connect the local refrigerant piping ahead of time, matching it to the liquid pipe and gas pipe marks
engraved on the installation panel (1).
English
Axis
Axis
Tab position
(3) (3)
Screw position
(2)
Screw position (In case of FXAQ40,50,63 type)
Front panel
(1)
Axis
(2)
Fig. 5
Tab position
Front grille
(2)
Fig. 7
Service cover
(2)
(3)
Handle
Screw
Insulating tape (4)
Refrigerant piping
Drain hose
Fig. 6
Tab
(4)
7