Rear Panel - Redx sapphire iii Owner's Manual

Rear Panel

1 2
1
Rocker Switch:
Use this rocker switch to turn the unit on or off. This connects/disconnects the AC power to the AC power
transformer. The amplifier is on when the top of the switch is pressed in. It is off when the bottom of the
switch is pressed in.
2
Power Cord Socket:
Here is where you connect the detachable power cord included with your amplifier. Plug the other end of
the power cord into an AC outlet properly configured with the voltage required for your particular model.
Be sure the AC outlet can supply enough current to allow full power operation of all the amplifiers plugged
into it. The outlet should be a three-prong socket that matches the power cord.
Unplug the amplifier's power cord from the outlet when the amplifier will be left unused for a long
period of time.
3
Speakon Outputs:
Connect the amplifier to the speaker using professional cables with twist-locking plugs.
4
Ethernet ports:
Connect the amplifier to PC/Ethernet switch and connections between amplifier via Cat-5 cables.
5
XLR Inputs:
Route line-level input signals into these combination jacks using XLR, balanced 1/4" TRS.
6A 6B
AMP MODE Switch (BRIDGE/STEREO):
Choose the amplifier mode by toggling the sliding MODE switch between the BRIDGE and STEREO position.
Be sure to power off the amplifier before changing the AMP Mode switch setting.
Sapphire III
Power Amplifier
3 4 5
6B 6A
10