Table of Contents
Advertisement
WARNING
In case there are several divers using the same code, the transmitter's code must be
changed before diving.
To assign a new transmitter code:
Slowly open the cylinder valve fully to pressurize the system.
1.
Close the valve. Depressurize the regulator so that the pressure is reduced to
2.
less than 10 bar/145 psi. Wait about 10 seconds, and slowly open the cylinder
valve again to re-pressurize to above 15 bar/300 psi.
The transmitter assigns a new code automatically.
NOTE
To re-pair the transmitter with the new code and the Suunto D6i dive computer:
In the DIVE mode of the Suunto D6i , long-press the DOWN button to enter the
1.
DIVE settings. Enter the Tank Press Pairing menu (Refer to Section 5.8.3. Setting
the tank pressure pairing). Short-press the SELECT button to bypass the tank
pressure ON/OFF selection (the tank pressure transmission must remain ON).
In the next menu, a Code number is displayed. Clear the code by short-pressing
2.
the UP button (toggle from "Ok" to "Clear"), and press the SELECT button.
Short-press the MODE button to exit the DIVE settings.
3.
48
If there are several divers using Suunto D6i with wireless trans-
mission, always ensure that each diver is using a different code
before starting the dive.
To pair on the new transmitter code, the Suunto D6i code must
be cleared first.
Advertisement
Table of Contents
