Advertisement
MEMO
16
Assembly Manual
Hughes 530 MD Scale Fiberglass Fuselage (TTR3837)
This kit is guaranteed to be free from defects in material and workmanship at the date of purchase.
It does not cover any damage caused by use or modification. The warranty does not extend
beyond the product itself and is limited only to the original cost of the kit. By the act of building this
user-assembled kit, the user accepts all resulting in liability for damage caused by the final
product. If the buyer is not prepared to accept this liability, it can be returned new and unused to
the place of purchase for a refund.
Notice: Adult Supervision Required
This is not a toy. Assembly and flying of this product requires adult supervision.
Read through this book completely and become familiar with the assembly and flight of this MD-
530. Inspect all parts for completeness and damage. Browse www.thundertiger.com for customer
service if you encounter any problems.
Specifications:
Fuselage Length (less rotor): 49" (1245mm)
Fueslage Width (less rotor): 18.75"(475mm)
Full Equipped Weight: 7.7 lbs (3500g)
Warranty
1
JK6014
Advertisement
Table of Contents
Related Manuals for THUNDER TIGER MD530
Summary of Contents for THUNDER TIGER MD530
- Page 1 MEMO Assembly Manual Specifications: Fuselage Length (less rotor): 49" (1245mm) Fueslage Width (less rotor): 18.75"(475mm) Full Equipped Weight: 7.7 lbs (3500g) Hughes 530 MD Scale Fiberglass Fuselage (TTR3837) Warranty This kit is guaranteed to be free from defects in material and workmanship at the date of purchase. It does not cover any damage caused by use or modification.
- Page 2 "Thin" instant CA adhesive. the parts are either missing or damaged, please contact your local Thunder Tiger authorized distributors for replacements. Neither your dealer nor Thunder Tiger authorized distributor can accept kits for return if construction has begun. Trial fit each part before gluing it in place. Make sure you are using the correct part and that it fits well before assembling.
- Page 4 PARTS CHECK LIST ASSEMBLY 3. Epoxy two wings in the place, either wipe off the excess epoxy or use masking tape to tape the 1. Note the orientation of the rocket launcher wing and guideline to keep the wing root clean after the masking trail fit in the place on fuselage.
- Page 5 Note: It is recommended to enlarge the strut hole for about 2~3mm wider as the Silicon Fairing will be installed in the hole. Do not glue the Silicon Fairing at this step. It is very important to make sure that silicon fairing is loosened in the hole instead of tight.
- Page 6 15. Unthread the ball link and install the sponge on the 22. Install the wire strike on the front windshield. The 17. Secure the helicopter onto the landing brace with 20. Trial fit the Horizontal Tail onto the vertical fin, note tail boom section where the plastic tube for the sponge big one is at the bottom and small one is on the top.
- Page 7 Test Flight 1. When hovering you MD, try to keep rotor speed at approximately 1600~1700 RPM. 2. Check the helicopter and fuselage to see if any screw loosened after each flight. 3. It is might be easy to get nose up in speed flight, please trim the elevator down when switching on the idle. 25.
- Page 8 No.4853...
Need help?
Do you have a question about the MD530 and is the answer not in the manual?
Questions and answers