Table of Contents
Advertisement
Notes
• Be careful not to touch the glass surface
of the lamp.
• The power will not turn on if the lamp is
not secured properly.
6
Restore the lamp cover to the original
position and tighten the three screws
with the phillips screwdriver.
Note
Be sure to attach the lamp cover securely
as it was. If not, the projector cannot be
turned on.
7
Connect the power cord.
The ON/STANDBY indicator lights in
red.
8
Press the
?/1
on.
9
Press the MENU key, and then select
the Setup menu.
10
Select "Lamp Timer Reset", and then
press the ENTER key.
A message is displayed.
11
Select "Yes", and then press the
ENTER key.
The Lamp Timer is initialized to 0, and
"Lamp Timer Reset Complete!" is
displayed in the menu screen.
42
Replacing the Lamp
key to turn the projector
12
Select "OK."
Caution
Do not put your hands into the lamp
replacement slot, and do not allow any liquid or
other objects into the slot to avoid electrical
shock or fire.
Note
To erase a message, press any key on the
control panel of the projector or on the Remote
Commander.
Disposal of the used lamp
For the customers in the USA
Lamp in this product contains mercury.
Disposal of these materials may be regulated
due to environmental considerations. For
disposal or recycling information, please
contact your local authorities or the
Electronic Industries Alliance
(www.eiae.org).
Advertisement
Table of Contents
