MAINTENANCE WORK ON FRAME AND ENGINE
Warning
Danger of accidents No braking effect when operating the rear brake.
–
After installing the rear wheel, always operate the foot brake until the pressure point is reached.
–
Check the rear hub rubber dampers.
–
Remove spacer
ring
.
Long-life grease (
–
Clean and grease the thread of the wheel spindle and nut
Long-life grease (
–
Clean the mating surfaces of the brake caliper frame and swingarm.
–
Install the rubber damper and rear sprocket carrier in the rear wheel.
601002-10
–
Stand the rear wheel in the swingarm and mount the brake caliper on the brake disc.
–
Push the brake caliper support and the swingarm
chain on the rear sprocket and mount the wheel spindle.
Info
Mount the left and right chain adjusters
–
Push the rear wheel forward so that the chain adjusters are in contact with the adjust-
ing screws, and tighten nut
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
601004-10
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
x
(
p. 81)
. Clean and grease the working surfaces of the bushing and shaft seal
p. 154)
p. 154)
.
.
into the fixing location. Lay the
in the same position.
M25x1.5
90 Nm
(66.4 lbf ft)
80
.