Table of Contents
Advertisement
Speaker and Sub Woofer Set Up
Adjusting the volume — TEST TONE Z
Adjust the volumes of the speakers, and at the same time
check to make sure all the speakers are connected and set
correctly.
2
4,6
5
1
Turn on the processing amplifier.
The ON-STANDBY indicator above the 1/u button on
the processing amplifier goes off.
2
Press SURROUND ON/OFF so that the SURROUND
ON/OFF button on the processing amplifier lights.
3
Press SURROUND MODE UP or DOWN so that
"NORMAL SURROUND" appears in the display.
4
Press TEST TONE on the remote.
You will hear the test tone from each speaker in
sequence.
If the test tone is not heard from a speaker
Press TEST TONE to turn off the test tone, then check
the following two points.
• Is the speaker connected correctly? (See page 18.)
• Is the speaker connection setting correct? (See
page 20.)
After checking these points, press TEST TONE again.
EN
22
5
Press CENTER +/– on the remote to adjust the
volume so that the test tone can be heard at the
same level from all speakers.
Press
CENTER +/–
1
Note
You cannot use REAR +/– if the SPEAKER SELECTOR
switch is set to "FRONT". ("NOW 3ch AMP MODE" appears
in the display.)
3
6
Press TEST TONE to turn off the test tone.
7
Turn MASTER VOLUME on the processing amplifier
(or press VOL +/– on the remote) to adjust the
overall volume.
7
To adjust
the center speaker volume within the
range of –20 dB to +10 dB (1 dB steps).
Advertisement
Table of Contents
