Hardware Wiring Check - COMPRO IP55 User Manual

Compro IP55/60/70 Network Camera

Hardware wiring check

1. Please check that the camera has been connected to either the wired or wireless network and has
been powered on for over 1 minute. You can check the status of the IP camera by checking the front
LED indicator.
Successful connection to the
network
2. Please check if your computer has a successful connection to the network.
3. If you are using the wireless network, please ensure that:
a. the IP camera is connected to the correct wireless access point.
b. you've correctly set the encryption type and key for the connection, when applicable. If you didn't
8-2
Initial Hardware / Software Setup
Steady (Blue)
The camera is unable to connect
to the network
Computer is connected
Table 8-2. Windows network connection
use a router on your network, the default IP address for the camera will be 192.168.0.128.
Notice!
You can check the status of the connection by logging
into your router à maintenance à log or similar wordings
in your router.
Blinking (Red)
The unit is either not working
or the LED indicator has been
turned off.
Table 8-1. LED status
Computer is not connected
Off