Network Configuration; Connecting Your Radio To Your Computer Network - Sangean REVERY R4 WFS-58 User Manual

Configuration

Connecting your radio to your computer network

1. Place your radio on a flat surface.
2. Insert the adaptor plug into the DC socket located on the rear of the radio ensuring that the plug is
pushed fully into the socket.
3. Plug the other end of the adaptor into a standard mains outlet.

IMPORTANT:

The mains adaptor is used as the means of connecting the radio to the mains supply. The mains
socket used for the radio must remain accessible during normal use. In order to disconnect the radio
from the mains completely, the mains adaptor should be removed from the mains outlet completely.
4. When you apply power, the display on the radio will light up and say: 'SANGEAN'. If this is the first
time that you use your radio (or after a Factory Reset) the display will show "Setup wizard" and "YES"
will be highlighted on the screen. Press the Select button to start the setup wizard and proceed to
step 5.

If press the Menu Left or Right buttons to highlight 'No' and press the select button. The screen will
ask if you wish to run the setup wizard again at the next start up. This will lead to the main menu.
Setup wizard
Start now?
GB
11